Forum Mustang
Technique => Technique Mustang 1965-1973 => Intérieur - Gén. 1 => Discussion démarrée par: claude911por le 06 Janvier 2012 à 08:59:25
Bonjour,
Je viens de consulter l'ensemble des posts traitant du sujet mais sauf erreur de ma part je n'ai rien trouvé de précis.
Auriez-vous plus d'informations à ce sujet ?
C'est pour une 1965; il semblerait qu'il soit placé à gauche du switch des essuie-glace !!!
Merci d'avance.
Claude.
HOW TO MEASURE AND DRILL FOR A 1965 OR 1966 MUSTANG GT FOGLIGHT SWITCH
Using a pencil, draw a vertical line 1 1/8" over from the door post (this will be at the lower, left hand corner of the dash).
Using a straight edge, hold the straight edge at the center of the hole in the door jam where the interior light button switch is located. Draw a horizontal line across the vertical line drawn, making a cross section.
Drill your hole 1/4" above these two crossed lines.
These measurements were taken from a 1965 Mustang Fastback factory GT and will work for a Mustang Coupe, but a Mustang Convertible with a power top may differ slightly.
Sur la GT d'usine, le commutateur de Foglight était situé sur l'extrême gauche du tableau de bord, près de l'interrupteur de courtoisie-lumière dans le chambranle de porte. Toutefois, sur une installation non-usine-type, le commutateur peut être situé n'importe où, y compris sous le tableau de bord.
Merci pour les infos.
Claude
You're welcome...