Démarré par hyann, 29 octobre 2011 à 21:32:50
0 Membres et 1 Invité sur ce sujet
CiterPedal Free-PlayDisconnect the clutch return spring from the release lever.Loosen the release lever rod locknut and adjusting nut.Move the clutch release lever rearward until the release bearing lightly contacts the pressure plate release fingers.Adjust the rod adaptor length until the adaptor seats in the release lever pocket.Insert the specified feeler gauge against the back face of the rod adaptor. Tighten the adjusting nut finger-tight against the gauge. The proper feeler gauge sizes are as follows:1966–67—6 cylinder—0.178 inch; V8—0.128 inch.1968–71—390, 427, 428, 429—0.178 inch; all others—0.136 inch1972–73—all—0.194 inch.Tighten the locknut against the adjusting nut, being careful not to disturb the adjustment. Torque the locknut to 10–15 ft. lbs. and remove the feeler gauge.Install the clutch return spring.Depress and release the clutch pedal a minimum of five times and recheck the free-play setting with a feeler gauge. Readjust if necessary.Finally, with the engine running at 3,000 rpm and the transmission in neutral, check the pedal free-travel. Free-travel at this speed must be at least 1/2 inch. Free-travel must be exactly to specification. Otherwise, the release fingers may contact the release bearing continuously, resulting in premature bearing and clutch failure.
Merci à Philippe Capellaro (AKA "Filou") pour la création du logo du forum.
Sujets actifs du forum
Page créée en 0.260 secondes avec 47 requêtes.