Topic: Lower control arm bushings - 65 fastback

[naika]

Hi Guys,

I am back into working on the car to be able to cdrive it this summer ( been stores for almost 18 months, replacing floor pans and other things)
I spent the weekend replacing all the bushings on the front end of the car, and ran into a hurdle.

I have the lower control arm prothane bushings and wonder where the 4 circular (rings) ones go???
http://www.jegs.com/i/Prothane/311/6-201-BL/10002/-1

Anyone knows where to install them? I couldn't figure out where to put them

Thank you
Franck

[naika]

Anyone?
I'm sure someone around here has replaced them

Thanks

[Topless_Horse]

I don't have the answer but Prothane does have a support tab on their website (http://www.prothanesuspensionparts.com/support/) that you can try.  They also have a toll-free number listed - 1-888-406-2330.  You could try that too.

Sorry I could not help more.

[Topless_Horse]

Just looked a little harder on the Prothane site and found the installation instructions too.  Maybe those would help you even more.  See http://www.prothanesuspensionparts.com/Installation_instructions/Prothane/6201.pdf

[naika]

Thanks a lot!
Then I understand that they don't necessarily mount, it depends if I have factory arms or not, but I see where they go now, so I'll check to see if I need to install or not.

Thanks!
Franck

[Jeff1967]

Good, then go do an American muscle car burnout under the Eiffel tower !!

[naika]

I think I would get in trouble