I need some advise

[Guest]

I own a 68 Mustang. I am building a 408 stroker(351 W). It has a comp roller cam with 242/248 duration @.50 and a 576/600 lift, aluminum heads with 2.02/1.6 valves and 215 runners, MSD dist with MSD 6AL and a blaster two coil, torker 2 intake that has been port matched to the heads, a 750 double pumper, and long tube headers with 1 3/4 primaries with 3 inch collectors. y question is what kind of power will this small block make? Any suggestion are appreciated. Thanks!!

Albert

[racedraper]

nice set up. weclome to the site. there are sites out there that will help you estimate HP but its better to use a dyno, but then there are differnt types of dynos and they give off differnt readings. it usaully cost 100 bucks to use one.

tell you what we should post peoples guesses and the one closest to the number I will give you  $25.00 gift card to the site sponcer of your choice , if the Thierry doesn't mind that is... :-P
   
so I guess 465 at the crank and 400 at the rear tires..

[Thierry]

As Racedraper says the best way to estimate the power is with a Dyno. Even if they are not 100% accurate they will give you a result close to the reality.
I have no idea what kind of power this would give so my guess won't be very usefull   :lol:   but someone with the same setup reading this topic may have the answer.