Forum > Classic Mustang Technical forum

Changing Manifold

<< < (2/9) > >>

Jeff1967:
Keep us posted on how it goes

65vertstang:
Will do.

Jeff1967:
I may do the same on my 67' and want to know how yours turns out?

Thanks

JJ

Joe AZ 2 PA:

--- Quote from: 65vertstang on May 23, 2012, 08:47:24 PM ---I am in the proccess of changing my stock two barrel to an Edlebrock performer intake and carb and in the old manifold there is a sensor of some sort at the middle front of the stock manifold. I was wondering if anyone could tell me what that might be. Also I thought I had a 289 but when I removed the stock manifold there was a 302 stamped in the valley between the heads, is this a 302?

--- End quote ---

Check the Edlebrock website and call tech support. They should be able to tell you what the gains will be since this is a common upgrade. . . .  8)

65vertstang:
Manifold update, its running but not until after finally getting the vacum hoses in the right place. It seems to run pretty hard but have'nt had much of a chance to test it. I was trying it out and noticed that every time I got on it antifreeze would blow out of the radiator cap, have a feeling that I have the thermostat in backwards. DAMMIT!

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version