Forum > 4.6 Mustang technical forum

Headlights not right...

(1/2) > >>

martinGT9:
I just recently replaced the bulbs inside my headlights and to do so I removed the headlights. When I put them back in the headlight rubber seal was not flush against the car (as shown in the picture). The drivers side headlight is fine, but the passenger side isn't. Anybody have any ideas of how to fix this problem?  ???







stang98:
Have you tried to adjust them at all? That could help a bit  :-\

martinGT9:
How would you adjust them? I've tried a couple things but it doesn't want to budge.  :-\

Soaring:
Make sure the screws that hold the bucket on are tightened equally.  Unscrew them and slightly tighten each one, then eventually tighten them both the same. 

stang98:

--- Quote from: martinGT9 on January 07, 2010, 11:56:57 AM ---How would you adjust them? I've tried a couple things but it doesn't want to budge.  :-\

--- End quote ---

the adjusters? They don't help?

Navigation

[0] Message Index

[#] Next page

Go to full version